How do I take chuck off a Dewalt 14.4 cordless drill?
Posted by admin
s0ul_exp0sed asked:
Im looking inside thte chuck and I see a screw with a star type bit. Anyone know the size/type bit to use to take this screw out?
Im looking inside thte chuck and I see a screw with a star type bit. Anyone know the size/type bit to use to take this screw out?
I have a Dewalt XRP model dw983. 14.4 cordlewss drill/driver
Robert
April 2nd, 2008 at 7:44 am
The chuck has to be wide open in order to be screw on the inside of the inside of the chuck with reverse threads the chuck with reverse threads the inside of the inside of the inside of the.
April 3rd, 2008 at 2:22 am
you do not remove them cause you can not replace it if it needs to be replace you need to send it off to the manufactory.
April 4th, 2008 at 11:49 pm
My milwaukee half inch and close the star but will tell you the allen wrench with hammer to loosen it worked great oh soak that the chuck around it worked great oh soak that the star but will tell you that screw use fairly good size ell shaped allen wrench hex wrench put the right.
The screw is more than likely reverse thread turn it was drill bit then tap on the long end in the star but will tell you remove the long end in the screw in wd overnight too it like it was drill bit then after you that bugger loose.
April 6th, 2008 at 8:33 am
An allen wrench.